Official Hackers Manual
- Can be used to modify the design, and is 3D-printable. Feel free to share modifications with the community.
* License for the Pandora Case Files:
- I, Dave Cancilier,
- still retain all rights and ownership an have rights to do anything with
- Pandora design/files as I wish, such as uploading to a website, selling the
- files, using them for derivative works etc.
- It is open for non commercial use, any company/persons using for monetary
- purposes or for resale must contact me first and possibly pay small
- royalties, or a one time fee on sales and/or use.
- By accepting and redistributing these files/design you are agreeing to these
- terms. If you do not agree, the files must be deleted/destroyed.
(End of License)
- silkprint, battery label, version label etc.
* License for the Labels and Manual:
- All files and documents within this ZIP archive are free for any use (commercial and non-commercial).
- You can do with them whatever you want - but you have to include the original ownership of them.
- The files are owned by
- OpenPandora GmbH
- Michael Mrozek
- Schäffbräustr. 11
- 85049 Ingolstadt
* (End Of license)
Here's a list of pinouts for the various connectors and boards.
Here's a pic of the board, some of the pinouts can be seen on it. 
What does it have?
- TV out
- Stereo line out
- Stereo line in
- The UART lines can also be used as GPIO (six of them) and PWM lines (four of them).
- Lithium polymer single cell battery
- 4000 mAH, 4 AH
- battery cover here: 
- reading out battery information: []
- TD043MTEA1 datasheet
- LTPS (8-bit parallel input for R, G and B, with separate horizontal and vertical sync)
- UART2 and 3 are available via the EXT connector, and via internal solder pads on the latest revision
- UART2 appears to support hardware flow control with RTS/CTS lines
- On the 2.6.27 Kernel UART3 is /dev/ttyS0
- On 2.6.37 or later, UART2 is accessible through /dev/ttyO1, UART3 is on /dev/ttyO2
- 6 are available on the EXT connector
- 7 are internal, 2 of which can be used as extra shoulder buttons
- 1 located on the LCD cable
- Yes, 1.8V 10-pin (board label JTAG)
- One at 1.8V from the OMAP (board label I2C3-1V8)
- One at 2.8V (board label I2C3-2V8)
- No internal USB ports
LED7 and LED8 can be added. You need to add FETs (Q17 and Q18) and resistors (R165, R166, R167 and R168) See the official "Pandora Hacker Guide" from Michael Weston for more details and component values.
This is the breakout board used by Pandora team members during development. Only a small number were made, and they are not available to the public. However a similar product (or gerber files) may be released in the future. A schematic for this board is available here: http://openpandora.ca/schematic/AV_Board_schematic.pdf