|
|
(7 intermediate revisions by 3 users not shown) |
Line 1: |
Line 1: |
− | How to set up wireless from the command line (this assums wlan0 is your wireless card):
| + | #REDIRECT [[WiFi]] |
− | | |
− | * log in as root
| |
− | su
| |
− | * Enable the wireless card
| |
− | ifconfig wlan0 up
| |
− | * Back up your wpa_supplicant config file
| |
− | cp /etc/wpa_supplicant.conf /etc/wpa_supplicant.conf.back
| |
− | * Edit your wpa_supplicatnt.conf to remove all but one 'network' block (or leave a couple if you're going to connect to more than one network)
| |
− | vi /etc/wpa_supplicant.conf
| |
− | * Edit that 'network' block with the appropriate information for your router then save and exit the file
| |
− | * Connect to your wireless network
| |
− | iwconfig wlan0 essid <ssid>
| |
− | * Authenticate yourself on the network
| |
− | wpa_supplicant -Dwext -iwlan0 -c/etc/wpa_supplicant.conf -B
| |
− | * Check your wireless card
| |
− | iwconfig wlan0
| |
− | * verify that the SSID is <Your Router>
| |
− | * wait 10 seconds
| |
− | * Request an IP address from your router
| |
− | dhcpcd wlan0
| |
− | * Check to see that you have a valid IP address for wlan0
| |
− | ifconfig
| |
− | * Log off root
| |
− | exit
| |
− | | |
− | Note: Although this should work, it may require hours of frustration with little explanation of why things are not working. I recently talked my friend through this over the phone and it took about 3 hours all together, and that was after I had already spent a couple of hours setting it up on a different network to make sure it was working.
| |
− | | |
− | References:
| |
− | [http://wiki.archlinux.org/index.php/Wpa_supplicant]
| |
− | [http://wiki.archlinux.org/index.php/Wireless#Manual_setup]
| |
− | [http://wiki.archlinux.org/index.php/Autowifi]
| |
− | | |
− | | |
− | [[Category:Tutorials]] | |