|
|
| (10 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| − | =Pin functions (mux)=
| + | #REDIRECT [[EXT_Connector]] |
| − | Currently this needs recompiling u-boot, but some easier control is planned.
| |
| − | | |
| − | By default UART2 pins are set up as GPIOs, and UART3 as an UART.
| |
| − | | |
| − | =Power supply=
| |
| − | Currently requires patching bootloaders (xload and u-boot).
| |
| − | | |
| − | This is connected to VAUX3 supply on PMIC, with these programmable voltages (200mA max):
| |
| − | 1.5V, 1.8V, 2.5V, 2.8V and 3.0V, with 2.8V as default.
| |
| − | | |
| − | '''warning''': at the time of this writing, both bootloaders (xload and u-boot) set this to 2.8V, so don't rely on this providing other voltages during reboot until you patch both bootloaders.
| |
| − | | |
| − | =GPIOs=
| |
| − | Can be controlled using GPIO sysfs class device, as described in beagleboard tutorials [http://bbfordummies.blogspot.com/2009/07/1.html here].
| |
| − | | |
| − | =UART3=
| |
| − | By default, kernel messages are directed there and a terminal with a shell is attached. The port runs at 115200 8N1 baud rate.
| |
| − | ==Disabling kernel messages==
| |
| − | To disable kernel mesages, you need to edit kernel boot arguments. Probably easiest way to do it is to create autoboot.txt and place on root directory of a card in slot1 with this content:
| |
| − | <source lang="bash">
| |
| − | setenv bootargs ubi.mtd=4 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw rootflags=bulk_read
| |
| − | </source>
| |
| − | Alternatives are using u-boot environment (configure through USB or UART3 serial before system boots up) or patching and reflashing u-boot itself.
| |
| − | ==Disabling attached terminal==
| |
| − | For this you need to edit /etc/inittab on pandora rootfs and comment out this line:
| |
| − | <source lang="bash">
| |
| − | #S:2345:respawn:/sbin/getty 115200 ttyS0
| |
| − | </source>
| |
